I shut off the water to the washer and the drip will continue for about 10 to 20 minutes.
Washer cold water valve leaks.
Use a crescent wrench and tighten the nut clockwise at the base of the stem while holding the handle in place.
In this episode we will repairing an old water valve for a washing machine hose hook up.
It s located in the back of your machine where the hoses connect.
Shutoff valves for the hot and cold water supply to a washing machine can develop leaks over time.
1 to repair certain types of washer water valves first turn off the leaky valve with the handle.
How to repair a washer shut off valve.
If it s leaking tighten the packing nut one eighth of a turn at a time until the leak stops.
2 open and close the valve multiple times.
There is little that you can do to repair the valve itself but you can clean the two inlet ports to restore full water flow.
The water inlet valve on your washing machine is the part that connects the two water hoses to the machine and it controls the flow of both hot and cold water.
It will continue to drip into the tub even days after the washer has been used.
The water inlet valve opens to allow water to enter the washing machine.
O ring replacement instructions for typical washer shut off valve.
After the washer has finished its cycle i am getting a small dip that is coming from the area where the washer fills up the tub.
Remove the old washer and slide on the new one.
If the water inlet valve is defective the washer may leak fill slowly or not fill at all.
To test your valve unplug the washer when the symptom occurs.
Reinstall the packing nut tighten lightly with a wrench don t over tighten at this or any other point and reattach the handle.
If you notice water drips on the wall or floor it s time.
If the leak persists before replacing the entire valve try this.
This inlet valve has a standard hose fitting inlet and 2 water outlets facing 45 degrees to the left.
A leak originating from the back of the machine could be caused by the water inlet valve.
If the neoprene washers are still flexible and clean this should work to stop the leak.
Try this easy fix if the leak is at the handle.
A problem with the valve can cause the washer not to fill properly or not fill at all.